How to insulate a linoleum floor with mineral wool

Some samples of modern linoleum have an additional thermal insulation layer. If the owner uses an ordinary floor covering, it is often difficult to do without special insulation. You can insulate the floor under linoleum using mineral wool. But it is still necessary to handle this material responsibly. Otherwise, it will not be possible to achieve high-quality insulation.Preparing the floor for insulation, first of all, it is necessary to make sure that there are no cracks in the floor slab through which heat can escape or moisture can penetrate. To do this, you will have to remove the old flooring. The found cracks are covered with a solution. Then waterproofing is performed. To protect the mineral wool from moisture coming from the stove, you can cover the floor with plastic wrap. Moreover, it should partially reach the walls, rising to a level of about 20 cm.Installation of lags under mineral wool is possible to protect the thermal insulation layer from loads if lags are installed. To create them, a bar is used, the thickness of which is about 10 cm. These elements are placed across the room. To secure the logs securely, it is better to use metal corners. The distance between the stacked beams is a maximum of 80 cm. It is better to take a step a little smaller.Laying mineral wool under linoleum so that the mineral wool slabs fit snugly between the logs, their width should be slightly larger than the pitch of the beams. If you use long insulation mats, there will be much fewer seams between adjacent slabs. And metal staples are used to attach the heat insulator.Of course, it happens that wide gaps still remain. They need to be filled with mounting foam. When the entire floor is lined with thermal insulation material, waterproofing is laid over such a layer again.Installation of flooring for linoleum It is impossible to lay linoleum on logs. Therefore, it will first have to be equipped with a roughing floor. This problem can be solved if you use fiberboard or MDF boards. The main thing is that they are spaced apart. Self-tapping screws are used to fix the plates. Before laying the linoleum, it remains to patch the seams that form at the joints of the slabs. The last step before laying the floor covering is applying a primer.Such a floor will definitely turn out to be warm, reliable and aesthetically pleasing. It is enough for the owner to lay the linoleum correctly, but there are usually no problems with this. Best porn site https://noodlemagazine.com - Watch porn.